JBL VTX A12 - 11 Disassembling an A12 Array; Open the Angle-Locks and Attach the VT

VT X A12 | Rigging Manual
40
11 - DISASSEMBLING AN A12 ARRAY
Carefully follow the next few step to correctly and safely disassemble an array.
STEPS:
• To de-suspend an array of VTX A12 cabinets, begin by safely lowering the entire array to a working height.
• Press the Lock Release Buttons to open the RED Angle-Lock mechanisms for the lower 4 cabinets. This will enable the
bottom 4 VTX A12 cabinets to collapse back together to the 10-degree position
• Attach the Vertical Transporter to the bottom cabinet by first connecting the rear attachment points (use the rear round
bar to lift the VT). After the rear attachment points have been secured, lift the front of the Vertical Transporter up and use
the front QRP’s to attach the VTX A12 Vertical Transporter to the VTX A12 cabinet.
11.1 - OPEN THE ANGLE-LOCKS AND ATTACH THE VT