radio control system
EN
5.3 Digital Trims
Transmitter gimbals are used for controlling the basic flight
functions like throttle, roll(aileron), pitch(elevator), and yaw(rudder).
Immediately under the transmitter gimbal sticks you can see four
push-buttons which are the programmable, digital trim buttons.
The digital trims are used for fine trimming of the flying model. When
the transmitter is turned off, the trim values are stored in memory
and are recalled when the system is turned back on.
Every model has its own trim setup. Also all flight modes may be
configured to use different trim configurations. By pressing one of
the buttons, the screen will automatically change to display the
graphic position of that trim. The transmitter trims feature an
acoustic step and centre beep alarm.
function used as automatic trimming. Digital trim steps and trim
In the "Digital trim“ menu it‘s possible to enable a special
range setting is explained in "Main menu->Fine tuning/flight
modes->Digital trim“.
5.4 Transmitter Battery Pack
ź Purple LED lights up - the transmitter is fully charged; the charger
is still connected.
ź Blue LED flashes - the transmitter is charging; the frequency shows
the state of charge. A more permanent glow means a higher state
of charge in the accumulator.
These colours can be changed by the user. Possible choices are
white, cyan, purple, yellow, blue, green or red.
The DC-24 II transmitter is powered by a Li-Ion type battery pack and
comes equipped with its own built-in advanced batter y
management and charging circuit. In switched-on position, the
transmitter LCD display shows the status and condition of the
battery pack. The Li-Ion battery is factory installed.
5.4 Charging.1
1. Plug the charging adapter into the mains.
Charging procedure:
2. Plug the cable with the connector leading from the charging
adapter into the USB C connector of the transmitter.
The charging status is displayed by a circular LED:
The transmitter can be charged with the supplied mains adapter
with a USB C cable. Charging time is approximately 3 hours. The
transmitter can be on or off while charging. The charging status is
indicated by the LED or if the transmitter is switched on, in the
display.
ź Green LED lights up - transmitter is on, charger is not connected.
42
To Next Page
Loading...