JETI model duplex DC -24 II - Swappable and Assignable Switches

radio control system
EN
5.2 Swappable and Assignable Switches
One of the most important features of a JETI transmitter is the switch
function assignment flexibility.
The DC-24 II transmitter automatically detects the type of switch
and assigns the selected function. There are many switches available
to suit different needs.See your Jeti retailer for switch availability.
Sa - 2 position spring-loaded long switch
Sj - 3 position long switch
Sb - 3 position short switch
Sf - 3 position short switch
Sh - 2 position short switch
Sd - 2 position long switch
Sc - 2 position short switch
Sg - 3 position long switch
Factory Switch Configurations for the DC-24 IITransmitter
Si - 2 position short switch
Se - 3 position short switch
You may either swap the existing switches around or take advantage
of the optional accessories and create your own custom
configuration.
Switch Exchange:
Be sure to disconnect the transmitter battery pack
connector.
3. Carefully hold the switch by its printed circuit board assembly
and slowly pull it out. Use this method to also remove and
exchange all of the other switches. After re-assembling and
turning on your transmitter the software will sound a warning
reminding you that you have executed a change. Always
reinspect all assigned functions of the switches before
attempting to fly.
1. Switch off the transmitter and remove the 10 screws that secure
the radio back cover. Next, remove the radio back cover.
2. With the specialized wrench (not included) carefully loosen and
remove the switch installation nut.
3
2
41