6
P5415479
3.3 Automatic Cooling/Heating Operation
In case dual setpoint is selected in automatic
cooling/heating operation, *during auto mode
both cooling setpoint and heating setpoint can be
selected.
By default, temperature when the cooling/heating
mode changes as follows.
Cooling mode changes to heating mode when the
indoor temperature is heating setpoint -2
°
F (-1
°
C).
Heating mode changes to cooling mode when the
indoor temperature is cooling setpoint +2
°
F (+1
°
C).
NOTE:
*
The function selection setting is required for
“Dual setpoint activation”. Function selection
setting is needed for the use of automatic
cooling/heating operation and changing AUTO
COOL/HEAT temperature. Refer to Installation
Manual and Service Manual for detailed
information.
To Next Page
Loading...
