Johnson Controls CIW01 - Adjusting Date;Time

30
P5415479
8.15 Adjusting Date/Time
• This function is used to adjust the date and time.
• Revise time setting periodically and adjust if
needed.
(Clock accuracy: difference within +70 seconds per
month)
• Embedded clock can work for approximately 72
hours. Reset the date and time if the controller
remains without power for longer than 72 hours
or the main power supply is OFF for a long period
of time.
• When adjusting time from the main controller, the
sub controller of the same refrigerant cycle is set
at the same time.
NOTE:
It is possible to adjust time from the sub
controller. If more than two minutes’ modifi cation
is done, the main controller is set at the same
time. (Check Main or Sub at the “Main/Sub-
Remote” from the “Help Menu” “Current Setting”).
(1) Select “Adjusting Date/Time” from the “Menu”
screen and press “OK”.
(2) Press “
” or “ ” and select “yyyy/mm/dd/
hh/mm”.
OK
Set date/time?
Adjusting Date/Time
Yes No
Sel.
Entr Rtrn
Back
(5) The confi rmation screen is displayed. Select
“Yes” by pressing “
” or “ ” and press “OK”.
The setting is confi rmed and the screen
returns to normal mode.
OK
Menu
Back/Help
OK
Menu
Back/Help
OK
Menu
Back/Help
OK
Menu
Back/Help
OK
Menu
Back/Help
OK
Menu
Back/Help
OK
Menu
Back/Help
(3) Press “ ” or “ ” to change the setting.
Press or keep pressing “
” or “ ” to adjust
numbers.
(4) After the setting is completed, press “OK”.