JOHNSON CONTROLS
20
FORM 160.54-O1
NAVIGATION
System
Used to provide additional system information.
Evaporator
A detailed view of all evaporator parameters, including
the programmable Leaving Chilled Liquid Setpoints.
Condenser
A detailed view of all condenser parameters, including
control of the liquid level functions.
Compressor
A detailed view of all the compressor parameters. This in-
cludes pre-rotation vane control, Hot Gas Bypass Control,
Proximity Probe calibration, and PRV calibration.
Oil Sump
A detailed view of all the oil pump and oil sump pa-
rameters. This includes the Variable Speed Oil Pump
when installed. It also controls the Seal Lubrication
functionality.
Motor
A detailed view of the motor controller parameters, spe-
cic to the controller type presently utilized on the chiller
system. This allows programming of the Current Limit
and the Pulldown Demand Limit values. For a VSD
system, the Adaptive Capacity Control and Harmonic
Filter information is controlled under this screen.
Setpoints
This screen provides a single location to program the most
common system setpoints. It is also the gateway to many
of the general system setup parameters such as Date/Time,
Display Units, Scheduling, Printer Setup, etc.
History
This screen provides access to a snapshot of system data
at each of the last 10 shutdown conditions.
OptiView Control Center
To Next Page