joule Modul-AIR All-E - Pre-Installation Notes

20 www.jouleuk.co.uk | www.joule.ie
Pre-Installation Notes
• Always store the Modul-AIR vertically
• Store the manual in a safe place in order to be able to use it as reference aer installation. For maximum
safety installers should always read the following warnings carefully.
• Store the provided manual in a safe location with the end user aer installation and remember to hand
it over to the new end user if the Heat Pump & Tank unit is sold or transferred.
• Only remove the device from the box at the installation site. Secure the device against falling.
• The Exhaust Air Heat Pump is compliant with the requirements of the Low Voltage Directive (2014/35/
EU), the EMC Directive (2014/30/EU) and the pressure equipment directive (2014/68/EU).
• The manufacturers shall not be responsible for damage originating from unauthorised changes or the
improper connection of electric and hydraulic lines.
• Do not use units if you see some damage on them and notice something untoward such as loud noise,
smell or burning.
• In order to prevent electric shocks, fires or injuries, always stop the unit, disable the protection switch
and contact Joule’s technical support if the unit produces smoke, if the power cable is hot or damaged,
or if the unit is very noisy.
• Handle electrical appliances with care. Never touch the device with wet hands, never touch the
device when you are barefoot.
• Always remember to inspect the unit, electric connections, refrigerant tubes and protections regularly.
These operations shall be performed by qualified personnel only.
• The unit contains moving parts and electrical parts which should always be kept out of the reach of
children.
• Unauthorised personnel should not attempt to repair, move, alter or reinstall the unit. These operations
may cause product damage, electric shock and fires.
• Do not place containers with liquids or other objects on the unit.
• Under no circumstances must the compressor block be opened or damaged.
• All the materials used for the manufacture and packaging of the Exhaust Air heat pump are recyclable.
The packaging material and exhausted batteries of the remote controller (optional) must be disposed
of in accordance with local regulations.
• The Modul-AIR Exhaust Air Heat Pump contains a refrigerant and must be disposed in an authorised
centre or returned to the retailer as special waste.