48
The following activation and setup procedure should be used for all JR 9303 systems.
Prior to activating the CCPM function, it is first suggested that the data reset function be performed to reset the desired model
number to be used back to the factory default settings.
Caution: Prior to performing the data reset function, it will be necessary to select the desired model number to be used.
A) Model Select/Data Reset
Press the ENT key while turning the power switch on to enter the system mode. Next, move the cursor to the MODEL SEL
function. Press the roll selector to enter the model select function. Select the desired model number to be used, then press the
roll selector. Next, move the roll selector to highlight LST, and press. Move the roll selector to highlight MDL RESET, then
press. Press the CLEAR key, then press YES to reset the data of the current model selected.
B) CCPM Activation
Move the roll selector to highlight the SWASH TYP function, then press to access the swashplate type function.
Press the roll selector to access the variations of CCPM mixing, then move the roll selector to select the desired CCPM type
(120 or 140). Move the roll selector to highlight LST to exit the system mode.
CCPM SOFTWARE ACTIVATION AND INITIAL ADJUSTMENT (CONTINUED)
1. JR XP9303 SYSTEMS: PROGRAM INPUT
MODULAT.
Devic. SEL
To Next Page
Loading...
