49
C) CCPM Settings
Turn the power switch on, then press the ENT key to enter the function mode. Move the roll selector to highlight the
SWASH MIX function, then press P. Once this has been completed, it will be necessary to change the value of the
aileron, elevator, and pitch functions from the factory default setting using the + and - keys.
D) Servo Reversing
Move the roll selector and highlight “Rev. Sw.” (Servo Reversing) appears on the screen, then press. Next, reverse channels
3, 4, and 6 by moving the Roll selector, and pressing as needed to change from NORM to REV.
E) Travel Adjustment
Move the roll selector and highlight “TRVL. ADJ.” (travel adjust) appears on the screen, then press. Adjust the values as
shown by moving the roll selector to highlight the desired channel, while using the control stick to select up/down, or
left/right values to be adjusted. Please note that the required travel values will vary based on the type of servo selected.
Note: The travel values shown for the rudder function are for use with solid state and Ring Sensor type gyros, like the JR G500T
or G7000T type gyros.
CCPM SOFTWARE ACTIVATION AND INITIAL ADJUSTMENT (CONTINUED)
Digital Servos/Super Servos
Standard Servos
PIT. +60%
REV.
To Next Page
Loading...
