xv
Do not turn off the power during Backup/Restore.
Otherwise, a function may fail, and an accident may occur.
Do not do the backup operation of data while sailing.
The Conning Display application should be ended to begin the data backup. It
becomes impossible to observe using the Conning Display and this may lead
to accidents.
The backup power supply (DC power supply, etc.) of the equipment must be
connected when recovery of the C drive image is performed. If the power
supply stops during recovery, an equipment activation fault occurs, causing
an accident.
Do not turn off the power supply during recovery of C drive image.
Otherwise, a function fault occurs, causing an accident.
In the case of turning on the power under the condition of low temperature, do
pre-heat more than 30 minutes.
Otherwise, an operation failure may occur and an accident may occur.
To Next Page
Loading...
