JRC JAN-7202 - Starting the Equipment with the os in the C Drive (Software Automatic Recovery)

9-45 Section 9 Maintenance & Inspection
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
19
21
23
24
24
26
27
Note
Since the equipment is started from the D drive, the usual C drive is displayed as the D drive
and the usual D drive is displayed as C drive. Therefore, note this point when selecting an
image file.
3 Click on the [OK] button.
Image file write-back operation starts.
Note
Do not perform any operation until write-back operation is completed. If any operation is
performed, the image write-back operation may fail.
At termination of recovery, the following screen is displayed.
9.10.3 Starting the equipment with the OS in the C
drive (Software automatic recovery)
Start this equipment with the OS that is written back to the C drive.
1 Click on the [OK] button on the screen that is displayed at termination of write-back
operation.
The equipment starts from the C drive and, at the same time, the applications and various OS
settings on the C drive are recovered automatically.
When recovery starts, the following screen is displayed for several seconds.
System
Start the recovery of the software...