JRC JAN-7202 - 9.1.5 Setting and confirming the sensor source

Section 9 Maintenance & Inspection 9-10
9.1.5 Setting and confirming the sensor source
9.1.5.1 Set and confirm the sensor source
1
Click on the [Menu] button at the bottom left corner of the screen.
The menu is displayed.
2 Click on the [Maintenance] - [Sensor Selection/Status] button on the menu.
The [Sensor Selection/Status] dialog box appears.
[1] [X] button
Click on this button to close [Sensor Selection/Status] dialog box.
[2]
[1]
[3]