Section 2 Name and Function of Each Unit 2-8
2.2.2 Task Switching Button
To switch to a required task, click on the task switching button.
Click on the task to be executed from [RADAR]/[ECDIS]/[CON] (Conning Display) /[AMS].
Memo
The [Primary] badge is displayed on the task that is set to the Primary function (basic task).
Example: ECDIS is the Primary function
2.2.3 Right Toolbar
The functions of the buttons of the right toolbar are as follows.
Day/Night button
The display color on the screen can be
switched to 5 levels according to the
brightness on the bridge.
For the details, refer to "3.7 Switching the
Day/Night Mode".
Display Brightness button
The brightness of the screen can be
switched within the range from 0 to100.
For the details, refer to "3.8.1 Adjusting the
Brightness of the Screen and Operation
Unit".
MOB (Man Over Board) button
When a person falls overboard, use this
button to mark the own ship’s position
when the button is clicked on, so as not to
lose the sight of the position.
For the details, refer to "3.9 MOB (Man
Over Board)".
Message notification
button
Not used on the Conning
Display.
Panel Brightness button
Switch the brightness of the operation unit to any of the 5 levels, 0
to 4.
For the details, refer to "3.8.2 Adjusting the Brightness of the
Operation Unit".
Task switching button
To Next Page
Loading...
