4-25 Chapter 4 Conning Display
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
4.2.3.23 Automatic sailing information
This section displays the status of the autopilot that is installed.
Note
Displayed when the automatic sailing option is attached.
Item Display contents
Autopilot mode Displays the automatic sailing mode.
No display: The [Navigational Data] combo box is blank space and the Switch to
equipment for Autosailing check box in the [Sensor Selection/Status] dialog is not
checked.
Track Control: The A/P (Autopilot) steering mode is set to Track Control.
Heading Control: The A/P steering mode is set to Heading Control.
Manual: The A/P steering mode is set to Manual.
Override: Override steering (interrupt steering)
Control mode Displays the automatic sailing control mode.
No display: Automatic sailing is not set.
KEEP: During automatic sailing/course keeping state
TURN: During automatic sailing/turning (TCS category C)
Assisted Turn: During automatic sailing/turning (TCS category B)
Turn mode Displays the automatic sailing turn mode.
No display: Automatic sailing is not set.
AUTO: Automatic turn mode
Notes
When the mode is switched to Override steering on the Autopilot side in Track Control mode,
Track Control is released and the mode is set to Override Steering.
Refer to the following information for the override steering method.
- Autopilot manufactured by TOKYO KEIKI:
“4.5 Override Steering Method (Option)" of the “Autopilot Additional Instruction Manual:
TCS model Category C (TOKYO KEIKI PR-6000 and HCS-9000)"
- Autopilot manufactured by YOKOGAWA:
“4.2.3 Override steering (option)" of the “Autopilot Additional Instruction Manual Autopilot:
TCS model Category C (YOKOGAWA PT500A and PT900)"
Automatic sailing mode
Control mode
Turning mode
To Next Page
Loading...
