JRC JAN-7202 - Page 201

8-9 Section 8 Adjusting and Setting Up Equipment (for Services)
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
20
21
22
23
24
25
APP A
APP B
Table A: Sensors that can be selected on CCU
Serial port Sensor name
Gyro Heading Sensor(NMEA), Heading Sensor1(NMEA)
*1
, Heading
Sensor2(NMEA)
*1
Heading Sensor(Gyro I/F), Heading Sensor1(Gyro I/F)
*1
, Heading
Sensor2(Gyro I/F)
*1
LOG Log(NMEA) , Log1(NMEA)*
2
, Log2(NMEA)*
2
Log(Gyro I/F) *
3
Selector
GPS GPS 1
GPS 2*
4
GPS 3*
4
GPS 4*
4
Selector
AIS AIS
*1: Only when there are two Heading Sensors
*2: Only when two logs are available
*3: Only when Heading Sensor(Gyro I/F) is selected for Gyro of CCU
*4: May not be displayed depending on the number of GPS units.
Setting serial ports on SLC/ALC
Set the serial ports on SLC/ALC that is installed as follows.
Setting item Description of Setting Setting value
CH1 to CH8
(RS-422)
1. Click on any of the tabs, SLC1(M) to SLC4(M)/SLC1(S) to
SLC4(S)/ALC1 to ALC4.
2. Enable the serial port of the corresponding channel by
selecting the check box.
3. Select a sensor
*1
to be connected to the corresponding
channel on the [Sensor] combo box. When not selecting a
sensor, select [ - ].
Enable: Select.
Disable: Clear.
CH9/CH10
(RS-422/RS485)
1. Click on any of the tabs, SLC1(M) to SLC4(M)/SLC1(S) to
SLC4(S)/ALC1 to ALC4.
2. Enable the serial port of the corresponding channel by
selecting the check box.
3. Select a sensor
*1
to be connected to the corresponding
channel on the [Sensor] combo box. When not selecting a
sensor, select [ - ].
Enable: Select.
Disable: Clear.
*1: The sensors that can be selected on SLC/ALC are indicated below.
However, the sensors that can be actually selected vary depending on the equipment setting.
Heading Sensor 1, Heading Sensor 2, Log 1, Log 2, GPS 1, GPS 2, GPS 3, GPS 4, Ship's Clock, Echo
Sounder(Depth), Echo Sounder 2(Depth), AIS, NAVTEX, Anemometer(Wind), Water Temperature
Meter, Current Meter, Climate Meter, TRI, Autopilot, Rudder, Engine/Propeller, Engine Telegraph,
Thruster, Azimuth Thruster, Generator, Fin Stabilizer, YEOMAN Digitizer, RADAR1(TT RX),
RADAR2(TT RX), Gyro Switch, Alert(to CAM), Alert(from Subsystem), Alert(to BNWAS), DSC,
IAS(MODBUS), IAS(NMEA), NAV/Alert, Plotter, GPS Buoy