1
2
3
4
5
6
7
8
9
10
137
OPTION
Place the center shaft on the
holder and press
FEED
until the
leading edge of the paper appears
at the cutter.
Close the paper cover by pressing
the top until it locks in position.
Holder
Switch
FEED
Paper Cover
Press
ALM OFF
to stop the
alarm.
Gently pull out the end of the
paper, holding down
RESET
until all paper is removed.
Press
POWER
to turn the
power off.
Open the paper cover, re-
move the center shaft, then
remove the roll core from the
shaft.
Refer to step 3 and “
●
Loading Printer
Paper” for further information about
loading paper.
● When paper runs out.
When about 50cm of printer paper remains, red lines appear on both sides of the paper warning that
paper supply is low. The buzzer sounds a warning when only a very small amount (about 10 cm) of
paper remains. When this happens, follow the procedure below.
First open the paper cover to check that the paper needs to be replaced.
9.3 NKG-52 Printer
TIP
To Next Page
Loading...