JRC JMA-1030 Series - Nke-1066 Scanner (1.5 Feet)

Chapter 1 INSTALLATION
20
1.4.1 NKE-1066 SCANNER (1.5 FEET)
Set the cable inlet side to face the stern.
The scanner certainly can be placed to face any direction during the initial setting.
However, it is strongly recommended that you install the scanner with the shortest cable length along the
mast.
bow
Ship heading
Fig. 1-4-1-1
 Open radome
Loosen the screws by using box spanner tool, then you can lift up the radome.
Fig. 1-4-1-2
stern
HORN ANNTENA
(1.5FT)
CABLE INLET
Loosen the screws
(4 points)