EasyManua.ls Logo

JRC JMA-1030 Series - 1.4 Connecting the Installation Cable

JRC JMA-1030 Series
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 1 INSTALLATION
19
1.4 CONNECTING THE INSTALLATION CABLE
With this new radar, JRC introduces two new small and light weight 4kW multi-speed scanners available in a
1.5ft (450mm) and 2ft (620mm) radome.
Both of them are the radome type, so antenna rotation is not affected by wind.
The microwave radiator is also protected by the radome, even in a poor weather conditions, it can be rotated
stably at all times.
Remove the radome, then open the metal protection cover, and connect the connector as the following.
Display side
Scanner side
Fig 1-4-2
Fig 1-4-1
braided shield
braided shield
(unit: mm)
(unit: mm)
screw locking
The installation cable can pass through a hole app.30mm when
the rubber cover flapping to cable side.
φ9.6±0.4mm

Table of Contents

Related product manuals