No. Item Setting range Initial value
U01
Target number of
pieces to be pro-
duced per day
The target number of pieces to be produced within the work
hours set with parameters U03 and U04 is set with this
parameter. (Display section
B
)
1 to 1999 500
U02
Number of times
of thread trimming
for one count of
product
The number of times of thread trimming to be carried out
until the counter counts one is set with this parameter.
(Display section
B
)
1 to 99 1
U03
to
U04
Work hours (from
the starting time to
the nishing time)
The starting time and the nishing time of sewing work is
set with this parameter.
* The operation rate is calculated using the work hours
excluding the time of work breaks.
0:00 to 23:59
8:00 to
17:00
U05
to
U06
Work break 1 (from
the starting time to
the nishing time)
The starting time and the nishing time of a work break is
set with this parameter. In the case no work break is provid-
ed, this parameters should be "0000".
(Caution)
* For U05 - U06, U07 - U08 and U09 - U10, enter the time
in the order from the earliest to latest.
* In the case the work break is not provided within the work
hours (U03 - U04), "non" will be displayed. Only the data
for which "non" is not displayed are eective.
0:00 to 23:59
12:00 to
13:00
U07
to
U08
Work break 2 (from
the starting time to
the nishing time)
0:00 to
0:00
U09
to
U10
Work break 3 (from
the starting time to
the nishing time)
0:00 to
0:00
U11
Type of display of
the target number
of pieces to be
produced
The type of display for the target number of pieces to be
produced (display section
D
) is changed over with this pa-
rameter.
1: The target number of pieces at the current time is dis-
played by calculating it at all times.
* Display section
E
: The actual number of pieces pro-
duced at the current time / The target number of pieces
to be produced at the current time × 100 (%)
0: The target number of pieces to be produced for the day
is displayed.
* Display section
E
: The actual number of pieces pro-
duced for the day / The target number of pieces to be
produced for the day × 100 (%)
0 - 1 0
U12
Changeover of the
display of operation
rate between ON /
OFF
The display of the operation rate (display section
E
) is
changed over between ON / OFF.
1: Operation rate is displayed
0: Operation rate is not displayed
0 - 1 1
4-8-2. List of production support parameters
< Production support screen >< Function setting screen >
Display
section C
Display
section D
Display
section E
Display
section A
Display
section B
* In the case the daily production quantity exceeds 1999, set the production support parameter:U02 to "10".
Then, the "number of pieces counter" adds one every time the sewing machine has carried out thread trimming
by 10 times.
– 34 –
To Next Page
Loading...
Need help?
General
