❼ ❻
❹
Display
section C
Display
section B
– 28 –
A
B
C
B
C
D
4-5-2. Overlapped stitching pattern
Overlapped stitching pattern can be programmed.
A : Number of stitches of normal stitching setting : 0 to 15 stitches
B : Number of stitches of reverse stitching setting : 0 to 15 stitches
C : Number of stitches of normal stitching setting : 0 to 15 stitches
D : Number of times of repetition : 0 to 15 times
1. When process D is set to 5 times, the sewing is repeated as A
→ B → C → B → C.
2. The number which exceeds 9 is indicated as follows:
A = 10, b = 11, c = 12, d = 13, E = 14, and F = 15.
[Setting procedure of the overlapped stitching]
1) Press
❹
to enable the overlapped
stitching pattern.
When the overlapped stitching pattern
is enabled, is displayed in the
display section
C
.
2) Press
❼
to put the sewing
machine to the overlapped stitching
setting state. In this state, one of the
items displayed in the display section
B
ashes on and o.
3) Move the process that ashes on and
o to the process (A, B, C or D) you
want to set. Then, change the number
of stitches and the number of times with
❻
.
To Next Page
Loading...
