JUKI DDL-8000A - Operation Panel Guide

❶
❷
❻
-A
❽
󱢳
❺
❸
❹
󱢴
󱢶
❻
-B
❼
-B
❾
󱢵
❼
-A
No.
How long the key
must be pressed
Function
❶
Short time Used to changing over the automatic reverse feed stitching at the begin-
ning of sewing to: Reverse feed stitching / Double reverse feed stitching /
Disable
Long time Used to change over the thread clamp operation between enable / disable
❷
Short time Used to change over the automatic reverse feed stitching at the end of
sewing to: Reverse feed stitching / Double reverse feed stitching / Disable
Long time Used to change over the needle bar stop position at the time of stopping
the sewing machine between up and down
❸
Short time Used to set the type of stitching to free stitching
Long time Used to change over the thread trimming operation between enable / dis-
able.
❹
Short time Used to set the type of stitching to overlapped stitching
Long time Used to change over the lifting of the presser foot during sewing between
"automatically lift / not lift".
❺
Short time Used to carry out setting of the polygonal-shape stitching.
Long time Used to changeover the automatic lifting of presser foot after thread trim-
ming between lift / not lift
❻
A
Short time Used to increase the maximum sewing speed
B
Short time Used to decrease the maximum sewing speed
4-2. Operation panel
– 23 –
󱢷