!0
9
!1
86
7
5) Press switch
6
or
7
to check the parameter functions (Nos. 1 to 3) and the parameter set values (dis-
played above switch
9
) related to the ancillary device "AH10" (MF auto hemmer device). The type of the
parameter function and the parameter set value vary depending on the ancillary device to be selected.
6) To change the parameter set value, press switch
6
or
7
to display the parameter function and its set
value you want to change. Press switch
8
or
9
to change the parameter set value.
7) After the completion of the changing procedure, press switch
!1
to return the screen to the previous one.
When you press switch
!0
, the parameter set value is discarded and is returned to the value before it is
changed.
5
2
6
31
4
■
Thread trimmer setting screen
1) Fine adjustment of the thread trimming action can be carried out.
2) In the case of the thread trimmer of LU-151* series, for example, the following parameters can be adjusted.
1: Instantaneous stop time of thread trimmer
2: Thread trimmer OFF angle 3: Tension release ON angle
3) Select the parameter you want to adjust with switch
1
or
2
. Change the set value of the parameter by
means of switch
3
or
4
.
4) After the completion of the changing procedure, press switch
6
to return the screen to the previous one.
When you press switch
5
, the parameter set value is discarded and the parameter set value status is
returned to the state before it is changed.
To Next Page
Loading...
Need help?
General
