ā 19 ā
Switch Description
6
With/without reverse feed
stitch at sewing end switch
This is the switch to turn ON/OFF automatic reverse feed
stitch at sewing end.
* This switch cannot be used with the sewing machine
which is not provided with automatic reverse feed stitch-
ing device.
7
Edge sensor switch
Selects use/disuse of the material edge sensor in the case
the material edge sensor (edge) is installed on the sewing
machine.
8
One-shot automatic sewing
switch
When this switch is pressed, the sewing machine automati-
cally operates until the material edge sensor detects the
material edge or until the set number of stitches is reached.
9
With/without automatic
thread trimmer switch
This switch is used to automatically trim the thread when
the material edge sensor detects the material edge or until
the set number of stitches is reached.
* This switch cannot be used with the sewing machine
which is not provided with the automatic thread trimming
device.
!0
Thread trimming prohibiting
switch
This switch prohibits all thread trimmings.
* This switch cannot be used with the sewing machine
which is not provided with the automatic thread trimming
device.
!1
Backlight switch
This switch is used to change over the operation of the
backlight of the LCD between ON and OFF.
!2
Reset switch
This is the switch to make the value of bobbin thread coun-
ter or sewing counter the set value. This switch is enabled
after thread trimming.
!3
Information switch
This switch is used to change over the screen between the
information function screen (sewing common data mode,
function setting mode, communication mode, version dis-
play, etc.) and the normal sewing screen.
This switch is enabled after thread trimming.
!4
Plus switch
This switch is used to increase the set value of the bobbin
thread counter or the number of pcs. counter at the time of
setting. It should be remembered that this switch is enabled
after thread trimming.
!5
Minus switch
This switch is used to decrease the set value of the bobbin
thread counter or the number of pcs. counter at the time of
setting. It should be remembered that this switch is enabled
after thread trimming.
!6
Counter/speed changeover
switch
This switch is used to change over the display between the
counter display and the maximum sewing speed limitation
display.
!7
General-purpose switch
This switch has different functions depending on the
screen.
To Next Page
Loading...
