JUKI IT-100D - Installation; Installation of the Sewing Machine Head

– 4 –
■
Installing the under cover
1) The under cover should rest on the four corners
of the machine table groove.
2) Fix two rubber seats
1
on side
A
(operator’s
side) using nails
2
as illustrated above. Fix two
cushion seats
3
on side
B
(hinged side) using a
rubber-based adhesive. Then place under cover
4
on the xed seats.
3) Remove air vent cap
5
attached to the machine
bed. (Be sure to attach cap
5
when transporting
the machine head in the state that the machine
head is removed from the machine table.)
If the sewing machine is operated with-
out removing air vent cap
5
, oil leakage
from gear box portion
7
may occur.
4) Fit hinge
1
into the opening in the machine bed,
and t the machine head to table rubber hinge
8
before placing the machine head on cushions
3
on the four corners.
5) Attach head support rod
6
to the machine table.
(However, this step is not necessary for the ma
-
chine with AK
9
device.)
23.5 mm
19.5 mm
1
4
A
B
4. INSTALLATIoN
4-1. Installation of the sewing machine head
WArNING :
• Perform the installation of the sewing machine by the technical personnel who have been trained.
• To prevent personal injury, ask our dealer or the electrician for electric wiring.
• Be sure to perform the work with two persons or more when transporting the sewing machine and use a
lorry when moving it.
• To prevent personal injury caused by abrupt start of the sewing machine, do not connect the power plug
until the set-up of the sewing machine is completed.
• Be sure to earth the ground wire to prevent personal injury caused by leak.
• Be sure to attach safety protection cover, nger guard, etc.
3
2
5
7
1
3
1
3
1
4
3
8
6
9