– 63 –
The cycle stitching is the shape sewing such as label attaching and the like, and a function created by sup
-
posing the case where a pattern, each side of which is different, is registered and sewn.
Cycle stitching can change over the different patterns in order and perform the sewing.
In addition, by setting the number of stitches, programmed stitching with different needle entry positions for
each step can be performed.
Cycle stitching can be set up to max. 20 steps and 10 kinds can be registered.
To perform the cycle stitching, it is necessary to register in advance the patterns which are used in each step.
■
Cycle stitching selection pop-up screen
1) Select
1
in the sec-
ond screen of the sewing
shape list.
2) Press switch
2
corre-
sponding to the registered
sewing, or patterns you
desire to edit in the cycle
stitching selection pop-up
screen.
3) Press
to display the
cycle stitching setting
screen.
(2) Cycle stitching edit
■
The second screen of sewing shape list
1) Press in the cycle stitching selection pop-up screen to display the new creation pop-up screen.
2) Nos. which have not registered at present are displayed in
1
. Select the No. you desire to obtain with “+” and “–”.
When
is pressed here, the screen returns to the former one without creating.
3) When is pressed, new creation is performed.
The No. which has been created is in the selective state. Continue to set the cycle stitching.
Standard delivery level of the key lock is “1”. When the level of the key lock is the case
other than “0”, be sure to change the level to “0” to perform the operation below.
6-13. Cycle stitching
(1) New creation of the cycle stitching
Cycle stitching pattern can be newly created.
■
New creation pop-up screen
w
q
q
q
To Next Page
Loading...
