JUKI IT-100D - CondensatOn Custom

– 46 –
* Separately set inputted zigzag width of condensation custom from that of normal sewing section. Set the
width within the range of maximum zigzag width limitation.
* By setting the width, the needle entry differs from actually inputted needle entry position.
■
The rst screen of reverse feed stitching setting (condensation custom)
Press to move the screen to the edit screen.
* For the editing procedure, refer to "6-10. Condensation custom".
■
The second screen of reverse feed stitching setting (condensation custom)
(3) Condensation custom
Condensation custom performs reverse feed stitching with the optional needle entry which has been input-
ted.
1) Select the shape of condensation with the rst screen.
1
: Select the shape of condensation at the sewing start.
3
: Select the shape of condensation at the sewing end.
2
,
4
: Needle entry position is displayed.
2) Set the width of condensation custom pattern with the second screen.
5
: Set the width of condensation custom pattern at the sewing start.
6
: Set the width of condensation custom pattern at the sewing end.
Press to display the second screen.
Press to display the rst screen.
▲
▲
t y
t y
q w e
q e
4