■
Teaching
Teaching can input the number of stitches of inputting step with the number of stitches which has been actu-
ally sewn.
1) Press
switch in the programmed stitching edit screen and the teaching mode is selected.
2) Depress the front part of the pedal to sew until the last stitch of the step is reached.
* At this time, input of number of stitches cannot be performed by turning handwheel by hand or using
needle up/down compensating switch.
3) Stop the sewing machine with the pedal in the neutral position and the number of stitches which has been
sewn is displayed on
2
.
1
: Set the step with "+".
2
: Number of stitches which has been sewn can be corrected by hand with “+” and “–”.
4) Make the step of
1
proceed to the subsequent step or make the sewing machine perform thread trim-
ming. Then the input of the number of stitches for the step is completed.
■
Teaching screen
■
One-shot automatic stitching
One-shot automatic stitching can be set by each step.
1) In the programmed stitching edit screen, press one-shot automatic stitching switch
5
to select the one-
shot automatic stitching. (When it is in the selected state, a mark is displayed on the side of switch
5
.)
2) In the step where the one-shot automatic stitching has been selected, the sewing machine will automati-
cally continue sewing, once the sewing machine starts running, until the number of stitches of the step is
reached.
Free needle entry position can be specied and optional zigzag pattern can be created.
As many as 20 patterns can be created and as many as 500 stitches of each pattern can be inputted.
(1) Custom pattern setting
■
Sewing shape list screen
1) Press switch
1
of
in the sewing shape list
screen.
Standard delivery level of the key lock is “1”. When the level of the key lock is the case other
than “0”, be sure to change the level to “0” to perform the operation below.
6-9. Custom pattern
q w
w
q
To Next Page
Loading...
