18
6. HOW TO USE THE OPERATION PANEL
6-1. Names and functions of the respective sections
1 Re-sewing switch
2 Needle up/down
compensating switch
3 Screen changeover
switch
4 With/without reverse feed stitch
at sewing start switch
5 With/without reverse feed stitch
at sewing end switch
6 Reset switch
This switch is used to continue sewing from the step on the way
after replacing bobbin thread when bobbin thread has run out during
program stitching step.
This is the switch to perform needle up/down compensating stitching.
(Needle up/down compensating stitching and one stitch compensating
stitching can be changed over with function setting No. 22.)
This is the switch to change over the screen.
This is the switch to turn ON/OFF automatic reverse feed stitch at sewing start.
* This switch cannot be used with the sewing machine which is not provided with
automatic reverse feed stitching device.
For the details, see p. 42.
This is the switch to turn ON/OFF automatic reverse feed stitch at sewing end.
* This switch cannot be used with the sewing machine which is not provided with
automatic reverse feed stitching device.
For the details, see p. 42.
This is the switch to make the value of bobbin thread counter or
sewing counter the set value.
For the details, see p. 67.
1 Re-sewing switch
2 Needle up/down compensating switch
3 Screen changeover switch
4
With/without reverse feed stitch at sewing start switch
5
With/without reverse feed stitch at sewing end switch
6Reset switch
7 Teaching switch
!5Power display lamp
!6 Smart media cover
!7 Smart media slot
(Smart media inserting opening)
!8 Smart media
Optional :
Part No.HX005750000
8 Information switch
9 Edge sensor switch
!0 One-shot stitching switch
!1
With/without automatic thread trimmer switch
!2Thread trimming prohibiting switch
!3Counter value setting switch
!4
Max.speed limitation variable resistor
13 4
!0
9
!5
6 !3
7
2
5
!4
!1 8
!2
（ ）
!7
!6
!8
To Next Page
Loading...
Need help?
General
