JUKI IT-100D - Page 87

– 84 –
Starting curve of the sewing machine is selected.
0 : Normal curve
1 : More sharp curve
Suction motion time of presser lifting solenoid [msec]
Pedal curve is selected. (Improving pedal inching operation)
Return of feed function
0 : Without function
1 : With function
Function of compensating stitching when turning handwheel by
hand at the time of completion of constant-dimension stitching
0 : Function of compensating stitching is effective.
1 : Function of compensating stitching is prohibited.
Function to reduce speed at the time of reverse feed stitching at
the start of sewing.
0 : Speed is not reduced.
1 : Speed is reduced.
Operation of needle up/down compensating switch is changed
after turning ON the power or thread trimming.
0 : Normal (needle up/down compensating stitching only)
1 : One stitch compensating stitching is performed only
when aforementioned changeover is made. (Upper stop
→
upper stop)
Max. sewing speed of the sewing machine head can be set.
* Setting varies in accordance with resistance pack to be
connected.
Thread release at sewing start function
Setting of number of stitches to actuate thread release function at
the start of sewing
Counter function selection
Whether counter operates every thread trimming or manually is
selected.
0 : Every thread trimming
1 : By manual SW
Pedal sensor neutral compensation function
0 : Pedal sensor neutral compensation function is ineffective
1 : Pedal sensor neutral compensation function is effective
＊
2
2
2
2
2
2
2
2
2
2
2
76
84
87
89
91
92
93
96
100
101
103
1/0
40 to 300
0/1/2
1/0
1/0
1/0
1/0
50 to MAX
0 to 9
1/0
1/0
F-SCS
0
T-PUT
100
F-PCS
0
TRS
1
F-PMAT
1
F-DSBT
0
F-MADF
0
S-MAX
4000
F-THLS
0
F-MAC
0
F-ANP
0
90
90
90
91
91
0
2
1
Sewing speed
Pedal stroke
Function to
select the
start-up speed
of the sewing
machine
Presser lifting
solenoid
initial start
suction time
Function of
pedal curve
selection
Return of
needle thread
feed
Function of
prohibiting
compensation
operation
after turning
handwheel by
hand
Function of
reducing
speed of
reverse feed
stitching at the
start of sewing
Function
added to
needle
up/down
compensating
switch
Max. sewing
speed setting
Thread
release at
sewing start
function
Counter
function
selection
Pedal sensor
neutral
compensation
function
*
Do not change the set values with asterisk (*) mark as they are functions for maintenance. If the standard set value set at the time of
delivery is changed, it is in danger of causing the machine to be broken or the performance to be deteriorated.
If it is necessary to change the set value, please purchase the Engineer's Manual and follow the instructions. (Descriptions of setting
in this list are the standard values at the time of delivery of LZ-2290A.)
However, contents of function setting are subject to change for improvement of function and performance without notice.
Ref.
Page
Setting
level
Panel display
Standard set value
DescriptionItem
No.
Setting range