– 5 –
7) Securely attach head support rod to the table until it goes no further.
8) Fix hinge stopper with screws . At this time, be sure to adjust so that the end face of hinge is spaced
45 mm from the end face of hinge stopper .
6) Install hinge on the bed with screw . Engage
the hinge with the rubber hinge of the table. Then,
place the machine head on the machine head
support rubber.
5) Attach a lter to the oil pan as shown in the
gure.
Install lter so that its multi-layered part is
brought to the right side as observed from you.
45
Chamfered section
Chamfered
section
Multi-layered part
Top surface
To Next Page
Loading...
