– 23 –
1) Pass the thread through sections to in the
numerical order.
2) Insert the thread from the rear side of looper
thread clamp and trim the thread. (The thread
end is retained under the looper thread clamp.)
3) Load a bobbin on bobbin winder shaft .
4) Lift bobbin winder lever in the direction of the
arrow.
5) When you start the sewing machine, the bobbin
rotates to automatically wind the thread on itself.
6) When the bobbin is lled up, the bobbin winder
lever automatically releases the bobbin and the
bobbin winder stops running.
1. The bobbin thread winding amount is
adjusted by loosening setscrew . The
bobbin thread winding amount is in-
creased by moving bobbin wider lever
upward.
2. If the thread comes off the thread ten-
sion controller, wind the thread on the
intermediate thread guide by one turn.
3-9. Winding a bobbin
1. This is the one-touch type bobbin wind-
er. When the bobbin is fully wound with
thread, bobbin thread clamp auto-
matically returns to the initial position.
2. To stop bobbin winding before the
bobbin is fully wound with thread, turn
the handwheel with threading lever
held lightly depressed to return bob-
bin thread clamp to the initial posi-
tion.
To Next Page
Loading...
Need help?
General
