– 10 –
Insert needle thread guide pin into the corresponding hole in top cover .
PLC-2710, PLC-2710-7
2-6. Installing the thread guide pin
PLC-2760, 2760-7, 2760L, 2765
Assemble the thread stand, set it up on the machine table using the installation hole in the table and tighten
nut gently.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
PLC-2710, 2710-7
PLC-2760, 2760-7, 2760L, 2765
2-5. Installing the thread stand
PLC-2710, PLC-2710-7:
One needle thread guide pin
PLC-2760, PLC-2760-7, PLC-2760L, PLC-2765:
Two needle thread guide pins
To Next Page
Loading...
Need help?
General
