– 13 –
1) Simultaneously pressing switch
and switch , turn ON the
power switch.
2) is displayed in the indicator
and the mode is changed over to the
adjustment mode.
3) Turn the pulley of the machine head
by hand until the main-shaft reference
signal is detected. At this time, the de-
gree of an angle from the main-shaft
reference signal is displayed on the
indicator .
(The value is the reference value.)
4) In this state, align one of the marker
dots on the pulley with marker line
on the pulley cover as shown in the
gure.
5) Press switch to finish the
adjustment work. (The value is the
reference value.)
• CP-18
3-2. Adjusting the machine head
(PLC-2710-7, 2760-7)
To Next Page
Loading...
Need help?
General
