– 27 –
Turn standard feed adjusting dial
and 2P feed
adjusting dial
to align the desired number with
marker dot
on the machine dial.
(1) Reverse feed stitching
1) Press down reverse feed control lever
.
2) Reverse feed stitches are made as long as you
keep pressing the lever down.
3) Release the lever, and the machine will run in
the normal feed direction.
(2) Manual one-touch reverse feed stitching
1) Press touch-back switch
.
2) Reverse feed stitches are made as long as you
keep pressing the lever down.
3) Release the switch, and the machine will run in
the normal feed direction.
(3) Changing over the stitching pitch
(PLC-2710-7, PLC-2760-7)
1) Press stitching pitch changeover switch
to
change over the stitch length to the one corre-
sponding to the scale mark on the 2P feed ad-
justing dial. (The LED on the switch lights up.)
1. Set 2P feed adjusting dial
at a value
smaller than the value set by standard
feed adjusting dial
.
2. Adjust the 2P feed adjusting dial when
the stitching pitch changeover switch
is placed in OFF.
3. In the case the stitch pitch is reduced
by adjusting standard stitch dial
,
move feed lever
up and down sev-
eral times before operating the sewing
machine.
Refer to "5-5. Operation switches (PLC-
2710-7, 2760-7)" p.37 for the details of
the 2P device.
4. ADJUSTING THE SEWING MACHINE
4-1. Adjusting the stitch length
To Next Page
Loading...
Need help?
General
