1-14
1-3-2. Replacing the Y-Axis Cableveyor
Y CABLE BEAR (E) (40060210)
1) Remove the SL3061232TN to detach the Y-Axis cableveyor from the CB_BR.
2) Remove the SM3051052TN to detach the Y-Axis cableveyor from the X-Axis assembly.
3) Remove the SL6061292TN to detach the FC_SUPPORT_Y_V2.
4) Reassemble the components in the reverse order of disassembly. At this time, pay special
attention so that the cables inside the cableveyor are not entangled.
Additionally, move the Y-axis to the foremost position and push the cables inside the
Y-cableveyor by hand to check that they are flexible.
Figure 1-3-2-1 Y-Axis Cableveyor
To Next Page
