Industrial Sewing Machine SADE
116
8.1 Inspections and maintenance
NOTE!
Prior to the adjustment or maintenance and parts replacement, dis-
connect the power supply (main switch set to position "O") and re-
move the power plug to prevent accidental starting of the machine.
Long lasting and efficient operation of machine SADE is dependent on the skillful han-
dling, systematic cleaning and the immediate removal of apparent defects.
Check the technical condition of the machine every day, before starting work.
Cleaning and maintenance must be carried out on the machine disconnected from the
power supply.
Internal parts of the head clean once a day.
Daily service consists of cleaning dirt located at the sewing head and of defects removal
resulting from the machine operation. Repair or replace defective or worn parts with
new ones (original).
Use only dry soft cloth and brush for cleaning.
Avoid using chemical and cosmetic solvents, they can damage the lacquer coating ma-
chine and/or its safety signs.
If it is found excessive noise, immediately stop the machine and carry out review and
repairs.
Do not use a vegetable oil to lubrication because of its ease of solidification at room
temperature, which can cause a lack of lubrication and machine damage. Fill the oil
tank with JUKI NEW DEFRIX OIL No.1.
Repair major damage should be entrusted with a service point.
Details on cleaning see clause 7.11.
Inspections
Perform regular inspections of the machine functioning, especially of the safety devices.
Also carry out the inspections after the introduction of changes in parameter settings or
after replacing components.
Periodic inspection and maintenance program must be carried out by competent and
trained personnel.
Regularly (once a month) clean up the oil reservoir of the oil pan and the filter case ap-
proximately.
To Next Page
Loading...
