Industrial Sewing Machine SADE
42
Take particular care when loading and unloading in the presence of bystanders who
should not be in the danger zone (maneuvering the load). For loading and unloading
activities there are needed two persons.
Be careful when unpacking the machine out of the wooden box. Unscrew metal band
and screws fixing the machine to the palled. Remove the machine from the pallet and set
it on a flat, level surface. Remove the stretch film. Remove machine components from
cardboard boxes. Mount the stand for thread spools and LCD monitor – see clause 4.2.
4.2 Installing the sewing machine components
NOTE!
Perform the assembly of the sewing machine
persons must be familiar with the machine structure.
To protect against possible personal injury due to abrupt start of the
machine, be sure to start the
following work after turning the power
off and ascertaining that the motor is at rest.
It is recommended to set the machine on level ground. Thanks to the wheels the ma-
chine can be easily moved. Remember to press the brakes when You pace a machine
at the destination.
Pneumatic components
(1) Installing couplings to the regulator
1) Pneumatic regulator
is installed un-
der working table regulator on mounting
plate ❺ by screw ❷, spring washer ❸
and nut ❹.
2) Mounting plate ❺ is fixed to
by accessory screws ❽.
3) You should only install couplings ❻
and ❼ on regulator ❶.
4) Connect ø
6 air tube coming from the
sewing machine to coupling ❻.
To Next Page
Loading...
