Industrial Sewing Machine SADE
27
3 INDUSTRIAL SEWING MACHINE LU-2810-7 SADE
DESCRIPTION
3.1 Intended use
Industrial sewing machine SADE is intended to airbags for cars sewing. It is designed to
work in a standing position. The work table height adjustment allows you to adjust the
machine to the operator's height.
The JUKI SADE side airbag cover workstation has been developed and constantly im-
proved to meet customer requirements concerning side airbag cover production.
In essence the machine is all about quality monitoring. The actual sewing isn’t any dif-
ferent as it would be on standard manually operated sewing machines. The sewing pro-
cess however is broken into defined aspects and as such monitored and controlled by
the JUKI SADE. Approved products will be tagged and relevant data of each production
cycle will be recorded. This information serves as source for a product traceability data-
base.
During development, daily practice of the trim plant played a leading role. This resulted
in the following philosophy that puts the JUKI SADE machine apart from other similar
workstations:
− reduce interference of the monitoring system to a minimum to prevent distraction of
the operator;
− record only unambiguous and relevant data;
− flexible implementation of customer requirements, in order to anticipate changes;
− open system architecture to enable integration of 3rd party components;
and most important:
− keep it simple… and user friendly.
Work safety regulations, accidents prevention and occupational medicine rules must al-
ways be fulfilled.
Unauthorized changes to the sewing machine SADE (including program) without
the manufacturer permission exempt him from liability for damages.
Meeting the requirements regarding the use of the machine, operating and repairs in
accordance with the manufacturer's instructions and strict compliance with the recom-
mendations is a condition of intended use. Using the machine for other purposes will be
considered as improper use.
In particular, the use of machine to purposes other than sewing airbags for cars is un-
acceptable.
When talking about machine sides it should be considered as at the figure 2.
To Next Page
Loading...
