Industrial Sewing Machine SADE
118
In the case fluid accumulation is observed in
A section of the filter regulator, turn drain
cock ❷ to drain the fluid.
1. If the quantity of oil in the hook is insufficient, adjust the quantity of oil by
turning the oil quantity adjusting screw counterclockwise to ensure that
the oil quantity in the hook is adequate. After that, adjust the quantity of oil
to the adequate one.
(Refer to "Adjusting the oil quantity in the hook"
p.13.)
2.
For the oil for hook lubrication, purchase JUKI NEW DEFRIX OIL No. 1
(Part No.: MDFRX1600C0) or JUKI MACHINE OIL #7 (Part No.:
MML007600CA).
3. Be sure to lubricate clean oil.
Cleaning the oil filter
To Next Page
Loading...
