JUKI SC-922 Engineer's Manual

– 13 –
3) Seam joining of the reverse feed stitching at the end of sewing (For thick materials)
Especially some sewing machine heads for thick materials are likely to fail joining the seam at the section of the
following figure even if the timing of reverse feed stitching at the end of sewing is compensated.
1 At the timing to move to the reverse feed stitching action,
the rotating speed at the section where the sewing machine
is rotated at a low speed can be changed.
Function setting No. 64
Example) Use for reference.
Condition Machine head of LU-1510N-7 (for thick materials)
Stitch length 6 mm
Number of stitches 4 stitches
ITEM No. 64 0sti/min
Standard
Condition Machine head of LU-1510N-7 (for thick materials)
Stitch length 6 mm
Number of stitches 4 stitches
ITEM No. 64 180sti/min
Section of EBT
Section of low
speed
Time
1
Speed
Stitch lenth
becomes small.
Stitch
length
slips off.

JUKI SC-922 Specifications

General

Brand	JUKI
Model	SC-922
Category	Sewing Machine
Language	English