– 55 –
(2) Flow of start & entry
Activate the setting mode with reference to “5.-(4) Function setting” and select function No. 142.
When function No. 142 is selected, the following are displayed.
A
B
Use the key
5
or
6
to select a program number.
Press the key
5
or
6
to select a command to be entered.
(Refer to "(3) Command entry" and "(4) Simplified program
command list" for command entry.)
Press the key
5
or
6
to select the "End" command.
Selection of this command allows program entry to end.
Press the key
3
or
4
to exit the entry mode.
Use the key
3
or
4
to exit the setting mode end the entry.
The operation of program 1 can be performed after "on" appears.
The program that was entered to "Pro1"
operates by turning off and on the power.
Use the key
5
or
6
to move to the state of "on" display
because the program cannot operates in the state of the
current display.
Program entry
(Command entry)
End of program entry
Press the key
5
or
6
to select the program entry.
Press the key
3
or
4
to move to the program setting mode.
Press the key
3
or
4
to move to the program entry mode.
The screen at left is the case of selecting program No. 1.
To Next Page
Loading...
Need help?
General
