Art. No. SC 1000 KNX
i Limiting value and hysteresis must be attuned individually to the brightness quality of the
installation location. Thus, it could be necessary in principle to specify a higher limiting
value in rooms that are light due to daylight or artificial light. In rather dark rooms, a lower
limiting value is normally advisable.
Fluctuations in brightness are to be compensated by the characteristic of the hysteresis.
Fluctuations of the ambient lighting, for example, can be caused by persons located in the
immediate proximity of the device.
Page 140 of 347
Software "Smart Control 501511"
Functional description
To Next Page
Loading...
Need help?
General
