Art. No. SC 1000 KNX
2 Installation, electrical connection and operation
2.1 Safety instructions
Electrical equipment may only be installed and fitted by electrically skilled persons. The
applicable accident prevention regulations must be observed.
Failure to observe the instructions may cause damage to the device and result in fire and
other hazards.
Make sure during the installation that there is always sufficient insulation between the
mains voltage and the bus. A minimum distance of at least 4 mm must be maintained
between bus conductors and mains voltage cores.
Do not operate the screen with sharp or pointed objects. The touch-sensitive surface
could be damaged.
Do not use sharp objects for cleaning. Do not use sharp cleaning agents, acids or
organic solvents.
The device may not be opened or operated outside the technical specifications.
Page 8 of 347
Installation, electrical connection and operation
To Next Page
Loading...
Need help?
General
