Jung Smart Control SC 1000 KNX - Setpoint Shift Function

Art. No. SC 1000 KNX
4.2.4.2.10 "Setpoint shift" function
The "Setpoint shift, internal" push-button function can be used to control the internal room
temperature controller. If this push-button function is used, it is possible to shift the setpoint
temperature of the controller in a positive or negative direction by pressing the button.
i It should be noted that the "Setpoint shift, internal" function is only possible with a button
configuration. The room temperature controller function must be enabled using the
parameter of the same name in the "Room temperature control" parameter node.
Otherwise the operation of the setpoint shift in the "Push-button extension module" function
section has no function.
Page 160 of 347
Software "Smart Control 501511"
Functional description