Art. No. SC 1000 KNX
4.2.4.2.9 "Controller operating mode" function
The "Operating mode switchover, internal" push-button function can be used to control the
internal room temperature controller. At the same time, it is possible to switch over the operating
mode. In the controller operating mode, a distinction is made between two functions, specified
by the "Button function" parameter. On the one hand, the operating mode (Comfort, Standby,
Night, Frost/heat protection) can be configured by a button-press to change over ("operating
mode change-over" setting). On the other hand it is possible to activate the Presence function
("Presence button" setting). The Presence function allows activation of Comfort mode or a
comfort extension on the internal controller.
i It should be noted that the "Operating mode switchover, internal" function is only possible
with a button configuration. The room temperature controller function must be enabled
using the parameter of the same name in the "Room temperature control" parameter node.
Otherwise the operation of the controller operating mode in the "Push-button extension
module" function section has no function.
Page 159 of 347
Software "Smart Control 501511"
Functional description