Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
4.2.5 Parameters
4.2.5.1 Display
Description Values Comment
h Display
External clock present Yes
No
The date and time can also be set via
the KNX communication objects "D.
Input Time" (KNX DPT 10.001) and "D.
Input Date" (KNX DPT 11.001). Setting
the date and time via the communication
objects is appropriate when there is a
master clock in the KNX system that is
controlled by a time standard (DCF77-
or IP-synchronisation). Cyclical transfer
of date and time based on the master
clock ensures that all devices in the
KNX system, as well as the Smart
Control, work synchronously.
The parameter "External clock available"
defines whether bus synchronisation of
date and time is possible. If the setting is
"Yes", the communication objects as
described are available which make bus
synchronisation possible. In this case,
the changeover from summer to winter
time is also controlled externally. If the
setting is "No", the objects for date and
time are not available. The internal
system clock of the device then works
autonomously and can only be set via
the administrator area locally on the
device.
If no external clock is present,
summertime/wintertime must be
changed over by the device itself if
necessary. For this purpose, the
parameter "Automatic summertime/
wintertime changeover" defines whether
or not a controlled changeover of the
time should take place by the internal
calendar.
Date display DD.MM.YYYY
MM/DD/YYYY
YYYY-DD-MM
YYYY-MM-DD
No indication
The date can be displayed in the status
line on display pages of the main
navigation. The display of the date can
be formatted differently and thus tailored
to the user's specific requirements. In
addition, the date can be displayed or
hidden as required. In the ETS, the
parameter "Display date" defines the
display format of the date display. In the
setting "no display", the date is not
displayed in the aforementioned places.
Time display 24 hours
12 hours
No indication
The time can be displayed on the start
page. The display of the time can be
formatted differently and thus tailored to
the user's specific requirements. In
Page 241 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English