Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
4.2.5.5 Scene
Description Values Comment
h Scene
Scene function ? Yes
No
The device can internally handle eight
scenes with eight actuator groups. This
parameter activates the scene function
and the other parameters and
communication objects, if needed.
Overwrite scene values
during ETS download?
Yes
No
If the values of the actuator groups that
have been changed on site by the used
are to be reset to the values preset in
the ETS during an application download
by the ETS, the setting "Yes" must be
chosen. If "No" is selected, the ETS
values will not overwrite the scene
values stored in the device, if any.
Scene 1 Recall via
extension object with
scene number
1 ... 64 If the internal scenes are to be recalled
via the extension object, a definite
number is required for each of them.
This parameter serves to specify the
extension number of the first scene.
Scene 2 Recall via
extension object with
scene number
1...2 ... 64 If the internal scenes are to be recalled
via the extension object, a definite
number is required for each of them.
This parameter serves to specify the
extension number of the second scene.
Scene 3 Recall via
extension object with
scene number
1...3 ... 64 If the internal scenes are to be recalled
via the extension object, a definite
number is required for each of them.
This parameter serves to specify the
extension number of the third scene.
Scene 4 Recall via
extension object with
scene number
1...4 ... 64 If the internal scenes are to be recalled
via the extension object, a definite
number is required for each of them.
This parameter serves to specify the
extension number of the fourth scene.
Scene 5 Recall via
extension object with
scene number
1...5 ... 64 If the internal scenes are to be recalled
via the extension object, a definite
number is required for each of them.
This parameter serves to specify the
extension number of the fifth scene.
1...6 ... 64 If the internal scenes are to be recalled
via the extension object, a definite
Page 342 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English