Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
push-button extension module.
This button-press does not cause the
configured function of the pressed
button to be executed. Only after then
next button-press will the configuration
of the button be evaluated and a
telegram be transmitted to the bus, if
applicable.
If "No" has been selected, alarm
signalling can only be deactivated via
the alarm signalling object. A button-
press will always execute the configured
button function.
Use the alarm
acknowledge object?
Yes
No
If alarm signalling can be deactivated by
a button-press, this parameter defines
whether an additional alarm
acknowledge telegram is to be
transmitted to the bus via the separate
object "Alarm signalling acknowledge"
after triggering by this button-press.
A telegram can, for instance, be sent via
this object to the "Alarm signalling"
objects of other push button sensors in
order to reset the alarm status there as
well (observe the polarity of the
acknowledge object!).
Acknowledge alarm
signalling by
OFF telegram
ON telegram
This parameter sets the polarity of the
"Alarm signalling acknowledge" object.
This parameter presetting depends on
the selected polarity of the alarm
message object.
Page 341 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English