Jung Smart Control SC 1000 KNX User Manual

Art. No. SC 1000 KNX
4.2.5.4 Push-button extension module
Description Values Comment
h Push-button extension module -> Button configuration
Type of extension
module
no PBEM
1-gang
2-gang
3-gang
4-gang
If an extension module is connected to
the Smart Control, the type of extension
module must be configured here.
Light period of status
LED for button-press
display
1 sec
2 sec
3 sec
4 sec
5 sec
This parameter defines the switch-on
time the status LED is lit up to indicate
actuation. The setting concerns all
status LEDs of the extension module
whose function is set to "Button-press
display".
h Push-button extension module -> Button configuration -> Operation concept of extension
module
Operation concept of
module buttons 1 and 2
(The same parameters
are available for the
other operating areas /
button pairs of the
extension module.)
Rocker function
(Rocker 1)
Button function
For each control surface of the
extension module, the user can specify
independently whether it is to be used
as a rocker with a common basic
function or as two different buttons with
completely independent functions.
Depending on this setting, the ETS
displays different communication objects
and parameter pages.
Button evaluation
(The same parameters
are available for the
other operating areas /
button pairs of the
extension module.)
Single area operation (only
as button 1)
Double-area operation (as
buttons 1 + 2)
If the operation concept of an operating
area is configured as "push button
function", this parameter can be used to
specify whether single-surface or
double-surface operation should be
implemented.
In single-surface operation, the entire
control surface is evaluated only as a
single "large" button. The surface can be
depressed at any desired point in order
to execute the underlying push button
function. In this setting, the button with
the even button number of the button
pair (e.g. button 2) is inactive and
physically not present.
In double-surface operation, the
operating area is divided into two
mutually independent buttons.
Button arrangement
(The same parameters
are available for the
Left / right
Top / bottom
In the rocker function and in the
pushbutton function with double-surface
principle, for each operating area the
user can independently specify whether
Page 311 of 347
Software "Smart Control 501511"
Parameters

Jung Smart Control SC 1000 KNX Specifications

General

Brand	Jung
Model	Smart Control SC 1000 KNX
Category	Controller
Language	English