Art. No. SC 1000 KNX
Button >>Y<< Module button 1
Module button 2
…
Module button 8
If the pushbutton sensor is to perform
the function of a specific button at the
end of the disabling state, this button will
be selected here.
Only visible if "Reaction of pushbutton
sensor at the end of disabling =
Reaction as button >>Y<< on pressing /
releasing"!
h Push-button extension module -> Disable -> Disable - button selection
Module button 1
Module button 2
…
Module button 8
Yes
No
The user can specify for each module
button separately whether it will be
affected by the disabling function during
the disabling state.
h Push-button extension module -> Disable -> Disable - disabling function 1 / Disable -
disabling function 2.
With the exception of the status LED control, the parameters available for the two disabling
functions are the same as those for the button functions.
h Push-button extension module -> Alarm signalling
Alarm signal display Activated
Deactivated
This parameter can be used to enable
alarm signal displaying.
When alarm signalling is enabled, the
ETS displays further parameters and up
to two further communication objects.
Polarity of the alarm
signalling object
Alarm when ON and
alarm reset when OFF
Alarm when OFF and
alarm reset when ON
The alarm signalling object is used as
an input for activating or deactivating
alarm signal displaying.
If the object value corresponds to the
"Alarm" state, all status LEDs flash at a
frequency of approx. 2 Hz.
If the setting is "Alarm when OFF and
alarm reset when ON", the object must
first be actively written by the bus with
"0" to activate the alarm after a reset.
An alarm signal is not stored so that the
alarm signalling is generally deactivated
after a reset or after programming with
the ETS.
Reset alarm signalling
by a button-press?
Yes
No
If this parameter is set to "Yes", active
alarm signal displaying can be
deactivated by a button-press on the
Page 340 of 347
Software "Smart Control 501511"
Parameters
To Next Page
Loading...
Need help?
General
